They are divided into three blocks :
heating chamber;
waveguide;
magnetron transformer.
To do this, disassemble the microwave oven . It is not recommended to do this yourself. Without knowledge and understanding of the operating principle of the equipment, this will not give the desired result and will lead to the final breakdown of the device.
If the user decides to disassemble and repair the household appliance with his own hands, he mustremember to follow safety regulationsFirst, the microwave oven is disconnected from the electrical network and the voltage is removed from the high-voltage modules using an electrical protective tool.
Why does the microwave oven spin but not heat?
The touch buttons on the microwave oven do not work
Replacing the Mica Plate in a Microwave Oven
How to disassemble a microwave at home: step-by-step instructions and practical advice
Each model has its own characteristics .What one device japan telegram data requires a Phillips screwdriver may not work for another.
First, unscrew the fasteners from the side and rear surfaces of the equipment . Remove the device casing by moving it back and lifting it up. Dismantle the power cord by disconnecting the terminals from the filter.
Then proceed to removing the front panel and control unit . To do this, carefully disconnect the cable from the control module. Remove the grounding fastener and the plastic fastener that secures the module, and take out the control panel. After this, remove the induction panel.
The door is dismantled . It is opened and the limiting plate is removed using a flat-head screwdriver. All actions are performed carefully so as not to damage the rubber seal. Then the door is lifted and removed. During reassembly, make sure that the door is installed parallel to the frame, without gaps. If necessary, adjust it.
To remove the magnetron, disconnect the cables from the transformer and capacitor .The fastener holding them to the frame is removed. The assembly is disconnected until the tip comes out to the end of the waveguide. After the magnetron is installed in place, the radiation level is checked.