Reduced voltage in the room, associated with its decrease in the whole house

[shapanwwuom]

The contacts are tested with a multimeter to determine their condition.Sticking should not occur.
Electrical characteristics are taken outside the circuit. To do this, a signal is applied to the control signal winding. This method involves assembling a circuit for testing. Various power sources and any measuring devices can be used.
Non-working timer
Here the only solution is to check the operation of the timer motor unit, as well as assess the contact of its internal part. Microprocessor microwave ovens are disassembled in case of malfunctioning, first of all in the control unit. All faults are detected there.
Lowering the heating temperature when placing food products in the oven
The malfunction always comes from underestimation of the radiation power. Three reasons for this phenomenon are identified:

Dirt accumulation on the waveguide window, which kuwait telegram data is located on the cooking chamber.
Reduction of signal power with incoming loads from a high-voltage transformer.
Malfunction of algorithms in the control module.
Camera contamination
You can check the cleanliness of the mica fiber by eye. There should be no accumulation of food residue. Any particles may prevent the radiation from passing evenly over the entire area of ​​the work surface. They should be washed well with gentle cleaning agents, trying not to damage the surface.

This situation is most common in remote rural areas where there is no quality power supply network. Energy suppliers can provide 200 volts at best. Using a multimeter, you can assess the voltage in the socket. If the readings are low, you need to increase them.

Important! If the situation is not corrected and the power supply is not increased, then the electrical appliances may work intermittently, the microwave transformer will supply an insufficient portion of energy for high-quality and safe operation.The magnetron can function fully and properly only with a high-quality supply of electricity.